How to set adjuster reserves before the first field inspection

Suburban street lined with mature trees and houses under a heavy, dark storm sky.

After a windstorm rolls through, the reserve numbers you post in the first 48 hours set the tone for the whole event. Finance wants a number. Reinsurance wants a number. And you're staring at a storm footprint with a few hundred claims trickling in and no real sense of which ones are total losses and which are a few missing shingles.

The old way of handling this: wait for drive-by surveys, lean on policyholder photos, average loss history from the last storm of similar strength, and post a reserve that's really an educated guess dressed up as a number. It works, eventually. But "eventually" is the problem when the first wave of adjusters needs to go somewhere tomorrow morning.

Why pre-inspection reserves usually miss in both directions

Most CAT teams set early reserves off reported wind speed and a rough per-policy average pulled from past events of similar strength. That number gets revised constantly as field reports come in, which is fine for accounting but not much use for deployment. Your best adjusters end up going to whichever claims called in first or escalated loudest. The buildings that took the actual worst hit often don't make that list at all.

The claims that scream loudest after a storm are rarely the worst losses. A policyholder with a collapsed roof section might not have cell service to call in for two days. Meanwhile your phone lines are jammed with gutter damage and a few missing shingles, because those people had power and a working phone and nothing better to do while they waited.

Setting reserves off what the roofs actually look like

The fix is to look at the roofs before dispatching anyone. Very-high-resolution satellite or aerial imagery over the storm footprint, captured within days of the event, lets you grade damage building by building instead of guessing from wind speed and call volume. A block with torn-off roof sections and visible structural damage gets flagged differently than a block with cosmetic shingle loss, and you can see that difference before a single adjuster drives out.

That changes two things at once. Your reserve number stops being a blind average and starts reflecting the actual spread of severity across the footprint, something closer to a real distribution of total losses versus minor claims. And your deployment list writes itself: the worst-graded buildings go to the front of the queue, the walk-away claims go wherever you have spare capacity, and nobody burns a day driving to a block where the real damage turns out to be a bent downspout.

This is the whole premise behind Windstorm Damage: a per-building damage grade across the storm footprint, generated from imagery days after the event, so reserves and deployment decisions get made off what's actually on the roofs instead of who called the hotline first.

What this looks like against 40,000 policies

Say a Category 2 storm tracks through a metro area and touches 40,000 policies in your book. Instead of one blanket reserve estimate revised weekly as field reports trickle in, you get a damage grade for those buildings before the first truck leaves the lot. Split the footprint into tiers, severe, moderate, minor, and set reserves tier by tier instead of as one figure for the whole event. Route your adjuster roster to the severe tier first, hand the minor tier to desk adjusters or virtual inspections, and file a reserve to reinsurance that reflects an actual spread instead of a single guess.

None of this replaces the inspection itself. An adjuster still has to walk the roof, write the estimate, and close the claim. What changes is the order they show up in and the number posted before they do.

What a damage grade can't tell you

A damage grade from imagery won't flag interior water damage and won't hand you a repair estimate in dollars. It grades exterior condition, which is the input a triage decision and a reserve tier need. The final line item on the claim still comes from an adjuster who walks the roof, climbs into the attic, and writes the estimate. The grade's job is pointing that adjuster at the right roof first.

If your reserve process still starts with a phone queue and a wind-speed lookup table, it's worth seeing what a damage grade across the footprint looks like before your adjusters hit the road.

← Back to the blog